【Sundia 三铃】Handle replacement for carbonstick 碳棍握把

【Product Specification】

• Sold in 1pair
• Made in Taiwan 

Replacement instructions (For sponge handle)

1. Cut off old handle using blade/knife, clean any glue residue on stick
2. Apply art white glue/polystyrene glue starting from middle of handstick 10cm towards down
3. Push in new handle(determine the correct direction of sponge) and let dry for 24hours. Remove glue residue at the end tip if any

Replacement instructions (For PRO silicone handle)

1. Cut off old handle using blade/knife, clean any glue residue on stick.
2. Sprinkle some water on handstick so that new handle can be insert in smoothly.
3. Flip down the top and bottom of handle outwards about 1cm, apply some hot glue inside evenly then flip the handle back (hot glue can increase friction and prevent handle from coming off)

【产品介绍】

• 价格为1对
• 台湾制作

更换指南 (仅适用于PRO软胶握把 )

1. 将旧的握把割除，清理干净残余棍上的胶水
2. 用美工白胶从握把中间往下涂约10cm
3. 把新握把由上至下推入碳棍（注意握把方向），静置风干24小时后，如尾巴处有胶水残留，抠掉即可
   

更换指南 (仅适用于泡棉握把 )

1. 将旧的握把割除，清理干净残余棍上的胶水
2. 在棍子上抹一点水，让新的握把更容易推入
3. 将握把头尾翻开约1cm，在里面均匀涂上一圈热熔胶，再翻回去即可（热熔胶可以增加摩擦力，让握把不易脱落）